Hi,I'm not able to manage FTD from its remote FMC when it fails over from ISP1 to ISP2.- 1 x FTD 1010 (7.0.1.1)- ISP1 connected to E1/1, ISP2 connected to E1/2- FTD Management Interface connected to E1/3 (routed port)- Route tracking enabled for ISP1...
Hi, I'm confused as to how to manage a remote FTD device using FMC located at another site: FTD (site 1) --- VPN --- [ASA w/ FP --- FMC] (site 2) With ASA I would select a "management" interface to manage the ASA over the VPN tunnel, but how do I acc...
Hello everyone, I'm hoping someone can answer this question for me - Does CDA 1.0.0.011 Patch 6 support Remote Desktop Session Hosts (Terminal Servers)? I'm asking because I'm experiencing the following issue - When one user logs into a terminal serv...
Hello everyone,
I'm currently running Firepower 6.2.3.9-54 on ASA 5516-X 9.8(3)-16 (currently running in monitor only mode). I've created an SSL Policy and attached it to an ACP. The SSL Policy is configured to 'Decrypt - Known Key' for a single web...
I figured it out -I created two EEM FlexConfig objects:My_EEM-FTD-MgmtIf_1event manager applet NAT-FTD-MgmtIf1event syslog id 622001action 1 cli command "no nat (mgmt-ftd,outside) source static Host-FTDMgmtIf interface destination static HostFMC_outs...
I have NAT configured but I can only use route-lookup if the original and translated source address is the same but it's not in my case (I have two rules - translate the Management Interface to (1) "isp1-outside" and (2) "isp2-outside" interface addr...
