About msrabie

msrabie · 02-16-2017

Hello Experts, Given: - 2960 48P-TTL Switch. - Before upgrade, It is configured successfully by Express Setup. Everything was fine using web interface. Problem: - After upgrade the tar of the IOS (which is correct and verified), the web interface i...

msrabie · 02-14-2017

Hello Everybody, Given: - Switch: Cisco 2960 - OS: Centos 7 - Serial port configuration: minicom - Used Configuration: 9600 8N2 ,Hardware Control Flow: No, Software Control Flow: No - Status: Online Target: - Configure a VLAN for the switch...

msrabie · 02-16-2017

Julio, Thanks a lot for these steps. My switch IP is : 192.168.36.1 and it could be reached from my PC via the web interface. So, I think I would start from step 4 with TFTP tool and telent. Am I right? Regards Mahmoud

msrabie · 02-16-2017

Julio, Thanks again for your time and support. 15.0.2-SE10a released on 2016 12.2.58-SE2 released on 2011 You could try to upgrade. How could I upgrade? From the web interface, the side link of Software Upgrade is not working. Could I achi...

msrabie · 02-16-2017

Julio, I have used Release 12.2.55-SE11 What about Release 15.0.2-SE10a?

msrabie · 02-16-2017

c2960-lanbasek9-tar.122-55.SE11.tar

msrabie · 02-16-2017

Hi Julio and Mark Thanks for your response. Have you tried with different browsers? I've tried the latest version of Chrome and Firefox. The same result. check your release notes where you download the ios version on the website see if there ar...

Member Since	‎02-14-2017 08:08 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	10

User Statistics

User Activity

Cisco 2960 Switch's Express Setup is not working after upgrade

Using minicom to configure Cisco 2960's VLAN - Problem: switch command prompt doesn't appear

Julio,

Julio,

Julio,

c2960-lanbasek9-tar.150-2

Hi Julio and Mark