I've a virtual machine (Windows 7) on my MacBook running on VMWare Fusion 6 running in bridge mode and can't get an IP address from my DHCP server. NAT mode in VMWare is working, but not an option.I've tracked down the problem with Wireshark to the D...
The 9500 switches are quite new. Due to delivery problems for the other switches (9300 series) in the project they were produced in Aug 2022. We did a normal RMA, because quick delivery was important. I remember another (different) case where a fault...
I had a Webex session with a TAC engineer today. The switch had shown the same symptoms as explained above during the Webex session. He has confirmed that it's a hardware fault and while we were working to fill the forms for the RMA, I've power cycle...
I get the same error message, although it is not the same with every power on:
Console output:
Initializing Hardware...
Initializing Hardware......
->> after a few minutes the fans go out for a fraction of a second, then the same again:
Initializing ...
We have the same issue and have opened a TAC case already. It took a while to prepare a central server to be able to receive PRT reports. Finally we got such a dump and the advice from the TAC engineer was to disable the second line if not used! This...
It's very sad that the standard time sync via NTP has been completely turned off with these phones! I don't understand why these phones have a problem with time derived by NTP and why this was causing problems with messages from CUCM. If a phone is a...
