I see that ISE 2.6 has been FIPS 140-2 certified. And I see that SNS 35XX series appliances have been FIPS certified. Are the SNS 36XX series appliances also FIPS certified or are they planning to be? If so, when? Thank you!
When upgrading a Catalyst 3750 or 3560 with the archive command from tftp, it downloads the image twice. Is it doing a file check? Why does it need to download twice?Thanks,W
I have seen some similar questions, but no definite answers, so I'll ask here. I have a CX module connected to a L3 switch on a management subnet. I want to use the managment interface of the ASA (since it is already connected for the CX) and place i...
We have some Windows 7 clients that are running the 4.8 agent. NAC will process the user and move them to the trusted vlan. However, the agent stays open and appears to keep running/processing something. THe user can minimize the agent and work norma...
Hello, I was wondering if anybody has run into any export limits with regards to the CSA reports. I.E. how many events/size can the reports be in order to export them. I know with the excel export there is a limit of about 16365 lines (or about 8150 ...
Thanks, Jason. Our CSE has already posted it on the internal BU site (which I don't have access to) and no one has responded. So thought I'd try this route.
Sorry for the delay, Lauren.In troubleshooting this issue, we ran into another issue. As a result, rebooted and the CAS and failed over to secondary. This fixed both issues that we were seeing. Unfortunately, by rebooting we could get to root cause.T...
Thanks, Lauren. Correct, it does stall on the Full Network Access screen. Unfortunately, we have had that parameter set to 2 seconds for quite a while now.Any other ideas?Thanks for your help.-Wyley
I typically use tftpd32. it's very simple. You should really use the User Guide for 3750's. You may have to use the archive command if you have downloaded the .tar file. Also, in case you are not aware, you will have to reboot your production switch...
That will make a difference. The IOS's need to be the same. Those are different. The switches do not play well together when there is an IOS mismatch. You can download the proper IOS from the software download section from Cisco.You really don't need...
