Hello,
I have configured external servers into "Settings -> External Services -> Destinations".
These servers will be used for Event Notifications.
I would like to know what is/are the interface(s) used by DNAC to send these events (VIP enterprise in...
Hello, I would like to implement 802.1x on AP connected on Catalyst 9300.The method used will be EAP-FAST.I have directly configured the 802.1x credentials and the EAP-FAST on the Catalyst 9800 WLC and it works well. With the new DNAC version, it is ...
Hi, I already have implemented an SDA fabric. I also have branch switchs managed by DNAC.I have created 2 application policy (HQ_policy and Branch_Policy) which are identical. I have keep the CVD application application, I have only requalified 2 ms-...
Hello,I have implemented SDA Fabric.According to the different cisco design guide, on Border nodes BGP should be configured like this : router bgp [underlay AS number] bgp router-id [interface] bgp log-neighbor-changes ! fusion router is an eBGP neig...
Hi,I have build a SDA fabric with Cat 9300 edges nodes.I have noticed that I have 802.1x sessions although the port are not configured for that.I have also noticed that uplink ports are in this state. switch#show authentication sessionsInterface MAC ...
According to your answer, the port switch hosting the AP is exclude from my wired policy ? It is strange, the switch could be configured by 2 application policy (wired + wireless) ? My wireless application policy scope contains the switch and the WLC...
I have open TAC case for this question. That command is only a recommendation, and the purpose of it is to advertise the Underlay Loopbacks to the Fusion (so that DNAC have reachability to these addresses). But having the “aggregate-address" command...
Hi Giuseppe, ISIS is used only for underlay.My underlay subnet is still redistributed into BGP (aggregate-address [underlay IP network summary] [netmask] summary-only). Moreover all underlay subnets (interco and loopback) are IS-IS L1, so they won't ...
By default, DNA configures access ports on switches in the Fabric with 'no macro auto processing' command.I don't understand why this command is enable globally and then disable on all ports. So I wonder if removing ‘macro auto global processing’ wil...
