Hi,
I just configure SSH v2 on my Cisco 4331 router. and I change my default SSH port. It is working successfully under LAN network. But I can't access the Router using WAN IP from a remote location.
What may be the Problem?
HI All,
I need to configure internet redundancy and need to be integrated with HSRP of my network. I am using 4331 ISR routers. The problem is I am using ipbase license only on these routers. so I need to find an alternative way for internet failov...
Hi All,
I need to create internet failover with hsrp. i try to integrate ip sla with hsrp. But ip sla monitor command is not found on my ios.
IOS version 15.5(1)T1
Router 1 Configuration As of now,
!interface GigabitEthernet0/1.10encapsulation...
Hi,
Still not working! But it is working from default port. If I apply the access list which one used for change the default port, ssh not working :(
Connection timeout shows on putty !!
Error: "Network Error: Connection timed out!"
Hello,
But if internet link is down, how router recognize wan link is down or not? It only recognizes if the connected interface link is down or not. I need to switch to active/standby mode by monitor wan link (internet) fails.