About paulostrander

paulostrander · 05-14-2019

We have 2 external offices using 2 site to site tunnels with an RV325 in the main office. In the other offices is an RV320, and in the other an RV180W. The tunnel to the RV180W is rock solid - really haven't had many issues. On the other hand, the...

paulostrander · 11-08-2018

Current internet installed: 50 down/10 up & 30 down/30 up. I've entered this information into the Bandwidth Management page. Also enabled the network service detection for each. Entered ISP host and entered the public IP of that interface. Havi...

paulostrander · 02-27-2017

Trying to set up my first VPN tunnel with an RV325 and RV180. The tunnel is setup and connected. RV325 is setup as 10.0.1.1, the RV180is setup as 10.0.2.2 From the 10.0.1.X side, I can ping a copier on the 10.0.2.X network. From the 10.0.2.x side, ...

paulostrander · 11-14-2018

I think i misspoke. I am trying to direct my internet from inside the office to use both internet ISP's in a load balancing scenario. I think your TTL would change for people initiating the connection to the internet whereas, i believe my computers...

paulostrander · 02-28-2017

That's all it was. It was lingering old gateway information. Thank you for your help!

paulostrander · 02-28-2017

Checked copier. It had the old gateway address. Corrected and now I'm receiving pings from the router. Going to go through the network and update all of my static IP's with the new gateway on the 10.0.1.x network. Makes sense as the 10.0.2.x netwo...

paulostrander · 02-28-2017

I'm trying to ping a copier on both sides. I'm able to ping the copier at 10.0.2.20 from the 10.0.1.x side. But not able to ping a copier on 10.0.1.20 from the 10.0.2.x side. I'd like to verify that the tunnel works - getting pings through, then ha...

Member Since	‎02-27-2017 01:01 PM
Date Last Visited	‎05-15-2019 12:03 AM
Posts	7

User Statistics

User Activity

RV325 VPN site to site tunnel to RV320 constant routing issues

RV325 Dual Wan load balancing issue

Connecting RV325 to RV180W via site-to-site tunnel

Re: RV325 Dual Wan load balancing issue

That's all it was. It was

Checked copier. It had the

I'm trying to ping a copier