Hi, my setup is pretty simple: (LAN1)ASA1 <-IPsec tunnel -> ASA2(LAN2) Previously, I have IPsec tunnel with Crypto Map and I could connect to ASA2's inside interface with ssh from LAN1. Now it's ipsec with VTI, nothing else was changed, so all access...

Hello, we have quite simple setup. (LAN1) - (ASA1) - (IPsec Tunnel) - (ASA2) - (LAN2) We have AnyConnect clients on ASA1. That clients should have access to LAN1 and LAN2.Recently we upgraded our ASAs to 9.7(4) version to get Tunnel interfaces.With c...

Hello, I have many unconfigured Cisco 2911 routers and I need to load initial config to them with TFTP. Startup config is empty. The problem is that routers aren't making any attempts to request IP address from DHCP or network-confg file from TFTP. I...