Hi, have configured some 1142n's, everything works in terms of .n but the reported client connection on the AP does match the published MCS definitions.eg so what does "Current Rate (Mb/sec) m6-4" actually mean in terms of MCS connection Anyone have...
Hi,I'm wanting to use the SRP527W (from Telstra) to route a block of assigned internet addresses (/29) over the WAN internet IP address. Is this possible on the 527W, or does it only do NAT routing?thanks in advance,regards Aaron
Andrew,ok got a SRP527W-U model, upgraded to 1.2.4(003), the WAN int is 110.142.120.52, turned off NAT, put in my Telstra assigned block as the LAN scope (203.39.56.176/29), configured DHCP etc. I get assigned an address from the Telstra Internet as...
Andrew,thanks for the reply, the WAN IP is not in the /29 subnet. So routing it is my only way forward. Didn't know if it would do none NAT routing.Device is new (being delivered to site in Darwin, I go there on Wednesday) so hopefully will be lates...