Hello All, Here is my topology running Segment-Routing with TI-LFA (Node + SRLG-Disjoint). SR with TI-LFA (Node+SRLG-Disjoint)P2 is running XRv9000 7.1.1Rest of the routers are IOS-XRv 6.1.2Here is the tiebreaker scenario. TI-LFA Tiebreaker (Node vs ...
Hello,I have a setup where 2 IOS-XRv routers are Option-B NNI peers within a confederation.The control plane works fine but the data plane is not forwarding any traffic received from the peer.I ran a 'debug mpls drop' on ASB-18 and at the same time a...
We had a PCIE error some time back due to power slicing. Power slicing is about shutting down a few NPs to save power on the line card.
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-7/system-management/configuration/guide/...
Hi,
If you can get a USB plugged in to the node, then the following is a tested method for migration from 32-bit to 64-bit XR using the manual approach of the following URL.
Migration Guide for Cisco ASR 9000 Series Routers - Migrating using Manual M...
Hi,
The (!) is missing because of ECMP, both routes are protecting each other.
Check the output for the following commands on XRV5:
show isis fast-reroute 6.6.6.6/32 detailshow route 6.6.6.6/32show cef 6.6.6.6/32
Also check the following repo...
