About 4flowShanghai

4flowShanghai · 05-22-2017

Hello There, Recently I have configure the GRE on both the cisco routers on two locations, I got everything setup like below, but the traffic cannot pass. configuration: Router A: interface tunnel0 ip address 10.10.10.1 255.255.255.0 tunnel source...

4flowShanghai · 03-24-2017

I have been setting up the call forward no answer for hunt pilot. Under the Forward Hunt No Answer tab, when I choose "Use Forward Settings of Line Group Member", then the call forward will not work. Anyone have any ideas. Thanks in advance.

4flowShanghai · 03-11-2017

I have the ISR G2 2921/K9 router, and I setup the SSL VPN on it. the user can connect to it, also user can access internet, but they cannot access the specified LAN through tunnel. Any advice? Thanks in advance!

4flowShanghai · 03-17-2018

This is a feature not supported on Cisco Jabber yet. Please set bug ID Cisco Bug: CSCus37131

4flowShanghai · 05-22-2017

I see the packets count increase on router A of ACL for gre, but there is nothing on router B for the same ACL, it looks like the packet did not reach to other side. Any ideas?

4flowShanghai · 05-22-2017

Hi, If I trace route from the source interface for example an LAN host, then the last hop is the LAN ip address of the router. Yes, I do have the matching routes on the peer.

4flowShanghai · 05-22-2017

Hi, I do have the routes in place, and as you suggested, I do try to ping the LAN behind the tunnels, still no luck.

4flowShanghai · 05-22-2017

Hi, Thanks for the reply. When you said point the routes exit tunnel interface, did you mean the routes to remote LAN? If you do, then yes. I checked tons of documents, if the tunnel is up, then both tunnel interfaces should be able to ping each o...

Member Since	‎03-11-2017 04:37 AM
Date Last Visited	‎09-17-2018 07:06 PM
Posts	13

User Statistics

User Activity

GRE tunnel setup but no traffic can pass

Hunt Pilot Forward Hunt No Answer not working

Cisco IOS SSL VPN cannot access LAN

Re: Jabber and Meet Me

I see the packets count

Hi, If I trace route from the

Hi,

Hi,