I am having an issue stacking an existing 3750e POE switch with a 3750x stack, the POE switch keeps coming up with version mismatch.GFM-STACK#sh switchSwitch/Stack Mac Address : a493.4cf7.4080 H/W CurrentSw...
We currently have 2 asa 5510 firewalls and need to add the Cisco ASA 5500 Series 4-Port GE SSM expansion module. Can this be added when the unit is powered on and running or does the firewall have to be powered off to install the expansion module?
We have 4 sites that are all connected together and are all routable across the LAN. We will be adding internet to all 4 sites and need to have redundancy. We will be using a default route for each site. What would be the best way to configure redund...
We are an ISP and we are trying to give internet access to a client via BGP. The client already has a primary connection with AT&T and is using our service as a backup. We have a complete routing table in our router and we are only giving the client ...
Is the command switchport mode access necessary on a port that is already configured with a switchport acc vlan XX command? Do these two commands accomplish the same thing?
Thanks for the info but that's not anything I am worrying about there are 4 other switches in the stack running ip services also we were actually given something we dont need as we dont use any of the feature sets in ip services its strictly a layer ...
I recreated the setup in the lab and it worked I had configs on both devices and the same licenses and it stacked without issue. Here are the results:WP-GFM-STACK#sh verCisco IOS Software, C3750E Software (C3750E-UNIVERSALK9-M), Version 12.2(55)SE3, ...
