About joneill70

joneill70 · 08-15-2016

I purchased a new WAP571-A-K9 V01 which is having issues with PoE+. When I connect the WAP to our new Aruba 2920-48G-PoE+ switch on port 3/17, I receive the following error when logging into the web console for the WAP: The power source of WAP devic...

joneill70 · 08-15-2016

I purchased a new WAP571-A-K9 V01 which is having issues with PoE. When I connect the WAP to our new Aruba 2920-48G-PoE+ switch on port 3/17, I receive the following error when logging into the web console for the WAP: The power source of WAP device...

joneill70 · 11-07-2016

I found the answer: The trick is to disable Dot3 LLDP TLV on the port on the switch. Once I did that, it negotiated the proper POE power.

joneill70 · 11-07-2016

Sorry to resurrect an old thread. I'm having this exact same issue with a WAP571. Did you ever find a resolution?

joneill70 · 08-22-2016

Hello Jonathan, Thank you for your response. Below are the answers to your questions: I am using the 5GHz band. It is configured as follows: Mode: 802.11a/n/ac Channel Bandwidth: 80MHz Channel: Auto Spectrum Analysis: Disabled I do not have any ...

joneill70 · 08-22-2016

On another note, I purchased a second WAP571-A-K9 just to verify that the WAP itself wasn't bad. I'm having the exact same issue with the second WAP.

joneill70 · 08-22-2016

I forced it to deliver 25W to the WAP. The same issue remains. Here are the port settings after forcing it to 25W: "show power-over-ethernet 3/17" Status and Counters - Port Power Status for port 3/17 Power Enable : Yes ...

Member Since	‎08-15-2016 01:38 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	9

User Statistics

User Activity

WAP571 PoE+ 802.3at Issue

WAP571 PoE+ 802.3at Issue

I found the answer: The

Sorry to resurrect an old

Hello Jonathan,

On another note, I purchased

I forced it to deliver 25W to