Thanks for the reply Rick and Andrew. Tryed Andrew's responce before I read the [Edit:... ] note. The command looked encouraging from the local interface... Said that it was going to reboot when idle, but nothing happed, as Andrew pointed out this was only for the voice application. The URL, for any one who wants to reset the voice application locally is(presuming default modem IP address) http://192.168.15.1/admin/reboot&xuser=admin&xpassword= Have been attempting to do a similar thing through the web interface, but this is proving tiresome. Sending the URL http://192.168.15.1/admin/reboot.asp&xuser=admin&xpassword= > seems like a decent start, but I will need to follow it up with a POST message that I haven’t quite figured out yet. Will keep you posted.
... View more
Hi. I was trying to use the uploading of a config.xml file to the modem to configure it (so that I can easily configure a fleet of modems to be the same). This approach has in the past appeared to work OK, but I recently attempted to use the same process to save the NAT Port Forwarding settings. After defaulting the modem, then sending it the configuration most the modem settings are updated as expected, but the Port Forwarding settings are lost. I would like this function to work, as it would avoid having to configure each modem through the use of the web interface. Best regards, Chris Gibson
... View more
Hi. I’m rolling out a fleet of SRP 527W modems for communications support of a remote appliance. The modems are mostly operating fine, but we have seen one modem’s data rate degrade over time, and eventually drop off the ADSL connection completely. Power cycling the modem brought it back to life for a time. I was interested if there was any way that the appliance could request a modem reset without going through the web interface. In some cases this may save getting a service person out of bed in the middle of the night just to reset a modem. Best regards, Chris Gibson
... View more
Hi Andy. Thanks for the reply. I had already visited the download centre and downloaded version 1.01.19, but 1.01.17 does not seem to be available there. My preference would be to use 1.01.17 to keep the fleet consistent (without needing to reflash the lot, half of which are already on site). If version 1.01.17 is not available could you please advise if there are any foreseeable problems if a http://192.168.15.1/admin/config.xml file taken from a 1.01.17 is then used to configure a unit with 1.01.19 version of the Firmware. Best regards, Chris Gibson
... View more
I have a “fleet” of SRP 527w modems, and all but one are running Firmware version 1.01.17. The one black seep is running 1.01.9 Firmware. I had some difficulty configuring the one with 1.01.9, as it was refusing to accept new /admin/config.xml files when initiated as a push from “curl”. It would though accept configuration if update was initiated in other ways. I would prefer all modems in the Fleet to be running the same Firmware Is version 1.01.17 Firmware available?
... View more