About patrick morrill

patrick morrill · 02-09-2015

I want to add a cost to the SVI on SWI-1 (on right of diagram) 10.0.255.11, so that OSPF prefers to route via 10.0.255.12, which is an SVI on SWI-2 (on left)Below is sh ip route from R01 (at top)O E2 10.10.0.0/16 [110/20] via 10.0.255.11, 00:27:17, G...

patrick morrill · 11-05-2012

Hi,I have a VPN runniing over an ADSL service with a relatively low upload speed of about 700kbps. I am running voice over this and It can be quite choopy, as you can imagine. I want to mitiigate this as much as possible by prioritising our EF (voice...

patrick morrill · 11-02-2012

I have a VPN on my ASA 5510 between (A)192.168.255.0/24 and (B)172.20.2.0./24. The purpose of the tunnel is to send kerberos tickets from our domian controller on the A side, across to a server at B, and receive a respose. I want to lock down inbound...

patrick morrill · 02-10-2015

Thanks for your reply, Jon.All sorted!!

patrick morrill · 02-10-2015

Hi Rolf,Thanks for your reply.Your suggestion sounded very promising, however, it didn't appear to work when I tried it.To confirm, have added highlighted lines:Switch 1:interface Vlan997ip address 10.0.255.11 255.255.255.248ip ospf cost 65000!router...

patrick morrill · 02-09-2015

That's not the case.Both SVIs are on the same network segment, with the router interface - so either can be used as next hop.sh ip route from R01 shows that 10.10.0.0/16, 10.20.0.0/16 and 10.30.0.0/16 are all route-able via either 10.0.255.11 or 10.0...

patrick morrill · 11-07-2012

Thanks all for responses!Jospeh... Sorry, I did originally state that I applied policing to the inbound of LAN interface, but then made a typo later. Cadet then said that policing should always be applied to the outbound, meaning I would have to appl...

patrick morrill · 11-05-2012

Thanks for the response. Just a couple of questions.Why use priority percent 33? Does that not limit the EF traffic class to 33% when congested. Shouldn't I use bandwidth percent 33? Also what difference does using shape average 650000 make, as oppos...

Member Since	‎11-02-2012 08:57 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	8

User Statistics

User Activity

Trouble adding an OSPF cost on an VLAN Interface (SVI).

Using class and policy maps to prioritise and drop traffic.

Securing inbound traffic on VPN using ACL. What is best approach?

Thanks for your reply, Jon

Hi Rolf,Thanks for your reply

That's not the case.Both SVIs

Using class and policy maps to prioritise and drop traffic.

Using class and policy maps to prioritise and drop traffic.