Hello Guys,I have a query about assigning a single device profile for multiple phones with different extensions.CUCM simply creates a device profile with extension mobility privilege that is associated with an end-user, when the user login from the w...
HelloAm using Cisco jabber 11.8.0.24 - 64 bit version on my IPhone IOS (10.2) and it is running on CUCM 11.x as well.
I have facing a problem that when a call is connected in jabber, the keypad is getting disabled. This is only in times when the call...
Hi
Am facing with 9971 SIP phones taking time to connect call outside. When phones are in idle state is getting delayed to turn ON (4 sec),if the phone is in off hook state for dialing the PSTN is also taking time to connect. At the same time we ha...
Dear Experts.... After long time ,I use to created a paging service on my client in CME as follows.....ephone-dn 86name Paging number 1234paging ip 239.1.1.10 port 2000 ephone 1mac-address 8478.ACC6.958Abutton 1:1 ...
Thank you Roger for the information, as we tried multiple UDP with single end user is working fine.But the requirement is to achieve single UDP with multiple extensions by an end user.if not possible, is there any work around in CUCM perspective. Pl...
Hi Kennett Am facing the same which you had discussed above.CUCM was migrated from 6.5 to 11.5, all phones are working fine in 11.5, except ATA 186 for fax service.Current version of ATA-186 in 6.5 is ATA030204SCCP090202A , but it is registered as ...
Hi Kennett Am facing the same which you had discussed above.CUCM was migrated from 6.5 to 11.5, all phones are working fine in 11.5, except ATA 186 for fax service.Current version of ATA-186 in 6.5 is ATA030204SCCP090202A , but it is registered as ...
Hello Peterson Did you fix the sip session timer by using the sip normalisation.as i have a same requirement from Rauland R5 team.May i know the update please...
