Hi am working on a design where i have two ASA firewalls in Active and Passive state and for Gre over IPsec connection i need one router in front of these firewalls .Can any one provide me config or tell what is best way to design this connectivity....
Hi , I have question over ipsec VPN access list to match traffic.I read that the access-list need to be in mirror condition to create Ipsec tunnel.I have point to multipoint scenario and I am using site to site VPN for every location.So my point is c...
Hi , i have question a Little dump one ,How multilink actually pass traffic .Is first link start sending data to second when it it full used or its kind of load balance between two links ?
Hi everyone,
I want to implement IPS in my network design .i have ASA 5545 on 30 different sites .Can anyone please suggest me solution for that .Do i go for FirePower software or hardware or any other option ?
Thanks in advance
Thank you Dennis, but what will be configuration on ISR side and ASA on those ports ,as i am using firewall as active and standby.
should i use /30 pool on both links i don’t think that will work as firewalls are active/Standby.
any suggestions?
...
Hi , I need Spoke to spoke communication even if HUB fails that why I created site to site tunnels.
So my question was for site to site tunnels with hub , can I use extend access list inside one single Transform set to match traffic for multiple site...