R. K,I would also take a look at the Cisco Storage Networking Cookbook, which covers both MDS and Nexus product lines for NXOS version 5.x. It's got a format that is easy to digest for people that know what they want to do but not sure what commands...
John,The SAN Health Advisor tool was integrated into DCNM-SAN in 5.2(1). You can get the same reports and information from DCNM-SAN. Seems that the section in your linked document was not updated. I have contacted the documentation team to update ...
Sami,SET is basically a load generator, like IOMeter but for FCIP traffic, it creates a virtual initator and target and generates a stream of reads or writes. You would then use other tools to measure at various locations. SET does provide some bas...
Sami,To measure the RTT use the command, "ips measure-rtt interface gigabitethernet ", this will send a ping issued from the FCIP engine on the linecard to the destination IP address, which should be the other end of the FCIP tunnel. If your RTT ch...