Steve,Thanks for your response. This is a question posed by one of my prospects who is evaluating op...

Hi,I have been trying to find a solution of using a Cisco IP phone remotely to connect to a UC 500 w...

Hello,I have a customer that has a defective 7940 phone and I would like to replace the phone. Is th...

I have finally configured the faxing as per the document and I am trying to use the service fax dete...

I have a Vista 64 bit laptop and would like to know if there is a UCC client for Vista 64bit? At pre...

I am running the same version and I get the error at flash.

I am configuring the fax to e-mail in the UC 500. I am following Marcos Hernandes note to configure ...

Patrick,Thanks for your prompt response. I have been having issues with the customer instllations fo...

I have used the wizard 2.1.0.0 to configure the system. Very often the AA does not work. Calls come ...

The location is US and I have used the wizard to configure the SPA9000 and SPA 400

I have an install with SPA9000 and SPA400 with 2 analog phone lines. Very often the outgoing telepho...

The links were very helpful and I had configured it. Its has to be done for all dial peers, 4 or so ...

Thanks for the configuration links. I was looking for an option to have speed dial menu avaliable on...

Following my discussions with John Guggenheim we figured out that we could do it thru the CME GUI. T...