About andyoww

andyoww · 03-11-2013

I'm coming from a 5505/5510 ASA to a 5512x.I see the following 7.2 commands are now set with the NAT command in 8.6:-------------begin 7.2 commands---------------------global (outside) 1 interfaceglobal (inside) 10 interfaceglobal (wireless) 1 interf...

andyoww · 03-18-2013

I was able to get TAC to help.This is what we (he) changed:no nat (inside,wireless) after-auto source dynamic INSIDE-PAT-SOURCE interfacenat (inside,wireless) source static LOCAL-LAN LOCAL-LAN destination static REMOTE-NETWORKS REMOTE-NETWORKSIt is w...

andyoww · 03-14-2013

UPDATED (I posted the wrong one earlier) OK.I'll post the entire config.Makes me so angry when I go through these & find commands & such that should not be there.!hostname ASANAMEdomain-name DOMAINNAMEenable password PASSWORD encryptedpasswd PAS...

andyoww · 03-13-2013

One correction from above.object network STATIC-PAT-UDP-5008I took out the dash between UDP and 5008 for standardization. (It caused an error when trying to call it later in the ACL.)Great stuff.I put these changes in my config & the ASA went in with...

andyoww · 03-11-2013

So:object network andobject-group The section is anything I want to choose?Of course, I would always make sure this is half-way descriptive for easier troubleshooting.Thanks again.

andyoww · 03-11-2013

You're right, I don't see anything in my config for theglobal (inside) 10 interfaceGuess I don't need it?nonat acl:access-list nonat extended permit ip 192.168.3.0 255.255.255.0 192.168.50.0 255.255.255.0access-list nonat extended permit ip any 192.1...

Member Since	‎06-22-2005 08:11 AM
Date Last Visited	‎10-09-2017 01:32 PM
Posts	6

User Statistics

User Activity

Command Changes From 7.2 To 8.6

Command Changes From 7.2 To 8.6

Re: Command Changes From 7.2 To 8.6

Command Changes From 7.2 To 8.6

Command Changes From 7.2 To 8.6

Command Changes From 7.2 To 8.6