About Milivoje Mirovic

Milivoje Mirovic · 02-12-2011

To properly understand the differences in IOS and IOS-XR MTU configurations, let’s start with explanation of interface “mtu <value>” command:- In IOS-XR this command is used to configure the L2 MTU.- In IOS this command is used to configure the L3 ...

Milivoje Mirovic · 07-23-2015

Hi Gustavo, you're indeed correct. Of course for deployments, suggestion is to have higher MPLS MTU than 1508B.

Milivoje Mirovic · 07-15-2015

Thank you Gustavo. Indeed 14B is for Src, Dst and Lenght/Ethertype. FCS is not counted.

Milivoje Mirovic · 10-21-2013

Hi,Principles are the same, if we're talking about core interfaces. VPLS, L2VPN and MPLS TE use MPLS MTU, while RSVP uses IPv4/IPv6 MTU so nothing special there.Regarding L2 MTU for L2VPN customer facing interfaces they should match. Please make sure...

Milivoje Mirovic · 01-29-2013

Hi Renato,MTU command you mentioned on 7600 is actually a L2 MTU.Therefore I would suggest to apply 9012+14=9026B MTU on physical interfaces of ASR9k.Let me know if you encounter any issues.BRMilivoje

Milivoje Mirovic · 10-03-2011

Hi Christopher,Just to give a bit of insight on difference between P and PX releases.P releases support only CRS-1 platformPX release is superset of P and supports both CRS-1 and CRS-3 platform.For more info on this plase check:http://www.cisco.com/e...

Member Since	‎01-19-2009 01:21 AM
Date Last Visited	‎08-30-2023 12:33 AM
Posts	3
Total Helpful Votes Received	45

User Statistics

User Activity

Differences in MTU Configuration Between IOS and IOS-XR

Hi Gustavo, you're indeed

Thank you Gustavo. Indeed 14B

Re: Differences in MTU Configuration Between IOS and IOS-XR

Re: Differences in MTU Configuration Between IOS and IOS-XR

Ask the Expert:Upgrading CRS1 System to CRS3