Level 1
Level 1
Member since ‎08-05-2003

User Statistics

  • 15 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

I'm configuring a new 2911 running c2900-universalk9-mz.SPA.151-4.M4.  In the config by default is "line 2"  its not a vty, aux or console line and I can't remove it,  Has anyone seen this before?line con 0exec-timeout 15 30password Removedloginline ...
Running a m9134 with 3.2. Trying to configure callhome to send a user defined command when a port is disconnected. Callhome works fine.This also works fine when I run "callhome test".but I can't get it to work when a interface changes status I.E up...
Hi, I'm having an issue with NAT on a Pix 525 running 6.3.4. I have two IP Address that I'm using a static nat on, one works and one does not. Here are the static entriesstatic (inside,vpn) netmask 0 0sta...
I have a site with approx 25 switches, 2 3750 G-12 stacks of two are the distribution layer for the complex. There are redundant links to both sets of stacks. Spanning-tree keeps re-calculating based on topology changes of links losing protocol. ...
I have 2 10meg EPL circuits, each one connected at layer2 to different 4k switch. Is is possible to wrap both of them in a etherchannel to get 20 meg circuit while they are on 2 different switches?
Community Statistics
Member Since ‎08-05-2003 06:20 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 15