Hii have a router 1751 equipped only with a Vic-2bri-NT/TE; i will use only one interface (so only two voice channels, one BRI); have i to use one PVDM-256k-4 or two PVDM-256k-4 (or one PVDM-256k-8) if i use only two voice channels and not all four v...

Hiwhere can i find a statistical analysis about hardware failure rate of : VIC-2BRI-NT/TE VIC-2FXS VIC-2FXO is there an official study about this argument produced by Cisco ?Thank you for your support

i have two pc equipped by network board (RJ45 interface); i connected them each other with a cross cable and i configured them using these addresses: pcA: 10.0.0.1 subnet 255.255.255.0pcB: 10.0.0.2 subnet 255.255.255.0i can ping each other succesfu...