i had designed the network using HSRP...for hardware redunduncy my configuration is below r1 l3_1 l3_2 l2 host_1 host_2On L3_1int fa0/0ip add 192.168.1.1 255.255.255.0standby 1 ip 192.168.1.10stan...
L3_2 sh standbby ----------------------------------------------------------------------------------------------------FastEthernet0/1 - Group 1 State is Standby 1 state change, last state change 00:00:18 Virtual IP address is 192.168.1.10 Activ...
it is happening when i am shuting down the port through the command line... but not when i am unplugging the link i have attached the sh standby on my previous post...debud of l3_1 here-----------------------------------------------------------------...
After enabling the int of l3 connectd to router..........-------------------------------------------------------------------------------------l3_1(config-if)#int fa0/0l3_1(config-if)#no shl3_1(config-if)#*Mar 1 00:27:03.275: %TRACKING-5-STATE: 1 in...
