Hi , I have a AS5400 connect via SIP to E1 R2 Argentina . When call from SIP send to R2 this is rele...

We are running this version over opteron "Version:"9.8(1)"" "Patch:"CSCOgs014/CSCOnn014"" This was w...

Hi, I need help from anyone because of a problem with our PGW2200.A few days ago I began to make swi...

I need to know how to capture messages CGUA CGU etc in Cisco PGW2200 Without having to use an extern...

I have installed the Cisco PTC-MT in a solaris10 opteron where there is the PGW2200 9.8. In CLI mode...

need to confirm if it is delayed because I have a problem of interworking , I have a 2821 ip-ip h323...

Hi guys , I need know if this method is Delayed or early media signaling for SIP protocol.Invite + S...

We have a AS5350 or AS5400 How can see the results of "Show controller E1" stats and config on SNMP ...

Any body can help me to configure a 3 15305 in mode Ring with stm-1?Need special parameter?I have ve...

Thanks , but I need a example of configuration in real life network.This link not explain how config...

I need documentation for how configure an MGX8880 with OC3-STM1 in MGCP connected to PGW.Thanks.

I see this later but I have loop-start configured .Need change to Ground?

Hello , I need a example for configure two 3640 back to back with fxs to fxo. voip-a---3640-fxs-fxo-...