I am trying to bring up a connection as given below c4948 - 10G -SR <->4900 - 1000 Base SXCan some one let me know if this is supposed to work or not .If there are any issue please feel free to discuss it here CheersAjai
This is my topologyI have Router A in AS 10 having an EBGP peering with Router B(AS20) and Router C(AS 30). They are having EBGP peering on WAN interfaces .I am injecting 10.0.0.0/8 network from Router B and Router C.I am seeing those routes i...
Hello, I have got a pair nexus 7000.It has got mutiple vlans enabled with ipv6 address .The vlans are trunked between the nexus via a port channel.After enabling the nexus with ipv6 I am seeing the following messages .Any idea why2011 Feb 21 ...
It would be nice , If this command could show packet drops on the ASIC level on the above mentioned card on Nexus 7018.But this command is not working on 7018. CheersAjai
This is what I see from sw#1 and sw#2...sw1# show ipv6 inter briIPv6 Interface Status for VRF "default"(1)Interface IPv6 Address/Link-local Address Interface Status prot/link/...
but will this command be of any use if there are packets that are hitting the 6500 with a ttl of 1 .I am trying to block the packets that hit the 6500 with a ttl of 1 ..Ajai
the task occupying cpu is ip CPU utilization for five seconds: 47%/14%; one minute: 42%; five minutes: 43% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 155 4565205722667043057 0 18.08% 18.62% 19.23% 0 IP Input ...
I have enabled only ip flow egress.My question was if the request comes in for an IP that is locally attached but not active as in host associated to that IP is not up ,will that be causing the look up to happen in software and cause the cpu to go h...