kokulsharma
Level 1
Level 1
desde ‎09-20-2006
‎08-18-2017

Estatísticas do usuário

  • 16 Envios
  • 0 Soluções
  • 9 Kudos Fornecidos
  • 0 Kudos Recebidos
Símbolos
5 Discussion Posts
10 Discussion Posts
5 Replies

Atividade de usuário

It's a weired issue in N7010, checking is anyone here came across the same?We did an upgrade from NX-OS 5.1.5 to 5.2.4 and found all M1 line card interfaces were stuck in initializing state for long time.'show module' status says ok. And we cannot ex...
We are migrating an IOS based PE to ASR9K with XR4.2. Customer has a local policy-map to match SNMP, telnet packets generaing from router and set Precedence value 3. !ip access-list extended MGMT permit tcp any any eq telnet permit udp any any eq snm...
When I insert any new SIP-800 & MSC in CRS-1, MSC stucks in "MBI-BOOT" state. It shows as "IOS-XR failure" for "show platform". After I reseat the MSC it booted fine and shows "IOS XR RUN".This issue is encountered couple of times in different CRS's....
Hi,Have anyone come across the following error message in CRS? "plaspa_server[123]: %L2-PLIM_ASIC-4-HW_WARNING : plaspa instance 0: (plaspa port 1 jacket slot 3) RSI Spi Error was reported"I couldn't get this message interpreted from Error message de...
Hi,I am testing selective QinQ with EoMPLS in ES20.I am eceiving vlans 30-200 from customer and tagging with outer vlan 250.Then i need to send this to a remote PE over EoMPLS and outer vlan to be stripped out by a switch connecting to remote PE.Cust...
Estatísticas da comunidade
Membro desde ‎09-20-2006 11:25 PM
Data da última visita ‎08-18-2017 03:56 AM
Envios 16
Kudos fornecidos a