tonymitchell
Level 1
Level 1
Member since ‎02-07-2006
‎10-09-2017

User Statistics

  • 38 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 10 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Hi, Not sure if this is a bug with ASDM, but when I try to add a virtual interface through ASDM I receive the following error when clicking 'Apply'... "With the current license device will only supports 2 fully functional interfaces. Third interface ...
Hi, Consider a small LAN using a collapsed core design with two Catalyst 3650 switches in a stack as the core/distribution layer. There are several 2960X switches with cross-stack EtherChannels to the 3650's. After enabling Rapid-PVST, best practice ...
Hi,We've had contradicting advice on AnyConnect licensing. We currently have two 5520 appliances in active/standby, each ASA had an AnyConnect Premium (50 peers) license installed, but following the (very sensible) change in 8.3 (I think), the total ...
Hi all...On a Cisco 5508 running 7.4.110, is it possible to configure the AP Mode on multiple acess points. I have around 15 new APs, but don't particularily want to go into each indiviual one to change the AP Mode from Local to FlexConnect.Can't see...
Hi,We have a 5508 WLC at our main site, with an 1141 AP at a remote site that is connected to the main site via an MPLS network. The AP is configured to use FlexConnect mode.I have a guest WLAN configured with the following key attributes:Seperate in...
Community Statistics
Member Since ‎02-07-2006 01:10 AM
Date Last Visited ‎10-09-2017 01:40 PM
Posts 38
Total Helpful Votes Received 10
Helpful Votes From
Helpful Votes Given To