About BRYAN HUNT

BRYAN HUNT · 08-14-2016

Hello, We have several of the SG300 series of switches. All seem to work fine with SNMP. We have one SG300-28 however that will not response to SNMP requests. We have: snmp-server serversnmp-server community READSNMP ro view DefaultSuper set in the...

BRYAN HUNT · 03-13-2015

Hello,I am setting up QOS for SIP phones on a Cisco 3560.I would like to set up individual ports for QOS, then test the results.On this switch model, it appears that the command to view output queues for port 1 is: show platform port-asic stats enque...

BRYAN HUNT · 03-08-2013

I installed 4 SPA112 units this week for fax machines at a client location. Three worked perfectly, one fails while executing the fax handshake.I updated the firmware to 1.3.1 (003), that did not help.The failing unit is attached to a Fax Server, wh...

BRYAN HUNT · 08-13-2012

Hello,I have a new client site with Polycom IP331 phones and an SF300-24P switch. We are manually setting the VLAN tag on the phones, but it appears to be being overridden by some setting on the switch. I have tried disabling every discovery servic...

BRYAN HUNT · 03-29-2012

Thanks.Bryan Hunt

BRYAN HUNT · 08-16-2016

Vinod, I had tried both Default and DefaultSuper in the past. I set it back to Default and tried again, no luck. I used the show snmp command. That seemed to only show the snmp config settings? Not any kind of traffic? Thanks. Bryan Hunt

BRYAN HUNT · 08-14-2016

Just tried to do a v1 MIB walk right now... Have not tried 2c or 3 yet.

BRYAN HUNT · 08-14-2016

Marvin, Thanks for the response. The switch is remote, so have not been able to do a packet capture off of a mirrored port. But, we can touch the switch via SSH and HTTPS, so I know that it is reachable from our site. And have confirmed that the UD...

BRYAN HUNT · 03-22-2015

Some follow-up on this question:- Apparently our model (and/or firmware) is a little dated. In newer models, the standard:show mls qos interface gigabitEthernet 1/0/1 statisticsdoes show the output/egress queue statistics at the end. Our model/firm...

BRYAN HUNT · 03-26-2013

Dan,I'm leaning more towards a physical issue (like impedance) than an issue with the Asterisk server, mainly because the other two ATAs worked perfectly out of the box without any special settings (even the optimized fax settings). They are all wor...

Member Since	‎12-13-2010 09:34 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	22

User Statistics

User Activity

SNMP not working in SG300-28

3560 Clear port-asic stats

SPA112 drops connection working with Fax Server

SF300-24P VLAN problem

WAP200 - How many simultaneous connections are supported?

Vinod,

Just tried to do a v1 MIB

Marvin,

Some follow-up on this

Re: SPA112 drops connection working with Fax Server