I have 2 Nexus 5K switches that I want to make the NTP servers for my network.  Nexus 1: 10.10.10.5Nexus 2: 10.10.10.6 I have read that you should only use the NTP master command if you basically plan on setting up the switches as their own NTP sourc...

With the "define interface range" command is there a way to include more than 8 individual ports? A lot of times I have devices that need to be on the same vlan on all odd numbered ports of a switch so was hoping there was a way to add them all to a ...

I have a Cisco 3650 that it booting into ROMMON.  In ROMMON, when I run dir I am only seeing these:switch: dirxmodem[0]: (read-only)null[1]: (read-write)bs[3]: (read-only)tftp[12]: (read-write)usbflash0[13]: (read-write) So I run flash_init and it se...

I am trying to setup the framework for our guest wireless network.    I currently have 4 locations with one of those 4 locations containing the datacenter.   Our firewall has a DMZ interface setup on it.  This interface has an IP of 192.168.1.1.  Thi...