Hi,
I assume you also purchased 2 x SFP-10G-LR= right?
The breakout ports should be configured : See "
Switching Between QSFP and SFP+ Ports"
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus3000/sw/interfaces/
6_x/b_Cisco_n3k_Interfaces...
Hi, yes there is a difference. The longer cables (7 and 10 metres) are called Active cables. The shorter cables (1 to 5) are called Passive. The Active cables require an "internal boost" to support or push the signal from one end to another. More i...
Hi, looking at a similar model (ME3400) - you can try the following : show interfaces [interface-id] [{transceiver properties | detail}] module number]Full info below :http://www.cisco.com/c/en/us/td/docs/switches/metro/me3400/software/release/12-2...
Hi GN, there is actually a module that can be used within the QSFP ports to convert QSFP+ to SFP+ or GLC. Have a look. CVR-QSFP-SFP10G=http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/transceiver-modules/data_sheet_c78-729336.html...
Hi Matt, you are correct. Confirmation here (If you do not have an inside router)http://www.cisco.com/en/US/docs/security/asa/quick_start/ips/ips_qsg.html#wp45196Please rate if you find this answer useful.ThanksMarco