I am interested in knowing if a route group is experiencing fast busys. Example 3 PRIs in a RG, all PRI channels in group are used therefore user recieves a fast busy. The fast busy counter for an individual PRI increments when the call is passe...
Researching the iSCSI configuration on the NetApp and NAM module for you but can help with the NFS configuration on the NetApp now. NetApp volumes have two types of qtrees (either NTFS or UNIX). It is likely that your system is configured to defaul...
NetApp devices support LACP with the channel-group mode active command only. The corresponding NetApp config would be vif create lacp (name) -b ip e0a e0b e0c e0d NOTE: I am using 4 interfaces but you use the number you intend.If you don't want t...
Under most circumstances you would choose IP. The 803.3ad as well as static etherchannels do afford you the option to choose the load-balancing algorithm on each side of the channel. This is because the load-balancing algorithm is used on the trans...
If your SAN vendor is recomending you configure the network for 9000 bytes then they are missing a piece of information and guiding you a little in accurately. An ethernet frame Jumbo or Not is comprised of payload, header and crc. If you are run...
