fredareid

fredareid · 03-18-2014

It really looks like your Flash is empty.

fredareid · 03-18-2014

What IP address are you using to connect to the device?

fredareid · 03-17-2014

After contacting TAC we did just that. We moved the card into Slot #4. After we did this we started ...

fredareid · 03-16-2014

All, We have replaced a line card in our 7k with a new line card. The old card seemed to have a rebo...

fredareid · 03-05-2013

We have alot of logs going through our Nexus 7000 that is referencing the above and below error "%AR...

fredareid · 11-27-2012

I would format the flash. If that does not work maybe the IOS is not for the hardware you are runnin...

fredareid · 11-27-2012

If you do a "dir flash:"? Is there an IOS on there already? What kinds of files are in there? You ma...

fredareid · 11-27-2012

Maybe this document will help you out:http://www.cisco.com/en/US/customer/products/hw/routers/ps221/...

fredareid · 11-26-2012

Maybe this would be a good quick overview. http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_...

fredareid · 11-26-2012

I am personally not sure what that intterrupt error is. Have you tried to format the flash?

fredareid · 11-26-2012

When you preformed the password recovery did you set it to boot back from the Flash? Also when you s...

fredareid · 11-01-2012

Thank you once again. I figured as much I just wanted to make sure,

fredareid · 11-01-2012

Thank you that is a very useful command.Turns out that the cable going into s0/1/0 is a old PRI, whi...

fredareid · 11-01-2012

I seem to be having an issue getting a 3xT1 bonded solution to work. I can get 2 out of the 3 T1s to...

fredareid · 07-20-2012

This is just something you can try real quick. Try to type the command "terminal monitor"

Date Registered	‎10-13-2009 11:09 AM
Date Last Visited	‎02-11-2019 05:11 AM
Total Messages Posted	57
Total Helpful Votes Received	15

It really looks like your