About balla-zoltan

balla-zoltan · 04-01-2013

We had a very interesting issue with one of our 2811 router. We have Checkpoint firewalls at some of our locations and they all send messages back to the management station using TCP port 257. At our Chinese location at March 10th around 10:30PM, our...

balla-zoltan · 03-17-2013

I have two routers configured for HSRP:interface GigabitEthernet0/1 ip address 10.10.10.2 255.255.255.240 ip flow ingress standby 10 ip 10.10.10.1 standby 10 timers 5 15 standby 10 priority 130 standby 10 preempt standby 10 track 100 decrement 250 lo...

balla-zoltan · 02-19-2013

What should be the bc and be value in the following configuration:policy-map block-sav class block-sav police cir 200000000 bc be conform-action transmit exceed-action drop violate-action dropThanks

balla-zoltan · 11-29-2012

Anyone has any issues running user traffic over the VSL link for devices that are not dual homed? I know that under ideal circumstance user traffic should not go over the VSL link, but we are not living in an ideal environment.Thanks

balla-zoltan · 01-26-2012

Hi,We have some issues with our 4948 switches namely there are a lot of drops on interfaces. Here is an example:GigabitEthernet1/19 is up, line protocol is up (connected) Hardware is Gigabit Ethernet Port, address is 001b.d417.a792 (bia 001b.d417.a...

balla-zoltan · 04-01-2013

Thank you, I have to schedule the change, we have a very strict change policy. You mentioned IOS upgrade, do you think it will solve the issue?Thanks

balla-zoltan · 04-01-2013

Thank you for your response. IP CEF is enabled at the global level, as the default. We have an alias that uses nbar, so that is why it is on the interface. I thought that the virtual-assembly was to protect the router from certain attacks where the a...

balla-zoltan · 03-19-2013

I figured it out in my lab that you cannot use an interface for tracking when you have sub-interfaces under it. Thanks for everyone's hepl.

balla-zoltan · 03-17-2013

Here is the configuration from the router that I have access to:track 100 interface GigabitEthernet0/0 ip routingdelay up 180interface GigabitEthernet0/0 mtu 9216 no ip address load-interval 30 duplex full speed 1000!interface GigabitEthernet0/0.412 ...

balla-zoltan · 03-17-2013

Correction, the second configuration should read:interface GigabitEthernet0/1 ip address 10.10.10.3 255.255.255.240 ip flow ingress standby 10 ip 10.10.10.1 standby 10 timers 5 15 standby 10 preemptstandby 10 priority 110 load-interval 30 duplex full...

Member Since	‎02-01-2005 05:19 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	54
Total Helpful Votes Received	5

User Statistics

User Activity

Disappearing Traffic

HSRP-New

Internet Policing

VSL

Cisco 4948 switches excessive drops

Disappearing Traffic

Disappearing Traffic

HSRP-New

HSRP-New

HSRP-New