About ssaunders42

ssaunders42 · 08-19-2013

Hi,we recently purchased a UCS setup to run our EXS hosts on. we have two 6248 Fabric switches and one 5108 chassis. I have setup for the most part everything I would think I needed to get a VM Host up and running for testing. Created IP pool for ...

ssaunders42 · 08-23-2013

I tried removing the vlan setting on the ESX and only having it set as native on the UCS but it still wouldnt work. this seems odd, but I switched everything over to the mgmt network and it started working. not sure if that is a must for hosts on ...

ssaunders42 · 08-19-2013

I recreated the port channels and the interfaces just to clean everything up. I now see the mac address on both the FI and the 6500's. I still connot ping the devices though. From the FI local-mgmt interface I can ping the default gateway network...

ssaunders42 · 08-19-2013

Hi Padramas - the vnic is set to the correct vlan and that vlan is set to native. I checked the mac address table on the FI and vlan 210 shows up with the correct mac address of the ESX host. the same mac address is not showing up in the table on t...

ssaunders42 · 02-15-2011

sounds like you want to trunk the multiple vlans across the network. Are the uplink ports already configured for trunking? If so you should just have to add the new vlans to the trunk command making sure to retype in all needed vlans, not just the ...

Member Since	‎02-15-2011 11:01 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	5

User Statistics

User Activity

UCS Uplinks to Core Network Issue

Re: UCS Uplinks to Core Network Issue

UCS Uplinks to Core Network Issue

UCS Uplinks to Core Network Issue

Re: Extending Vlan to a different subnet