About smithcolm

smithcolm · 10-03-2013

Hi.i have an ASA 5510i have an exchance owa server that gets all traffic from 1 IP on 1 interface (and then firewall allows only HTTPS)I need this owa server to be able to access its own hosted website from its external adderss, which right now it c...

smithcolm · 09-18-2013

Hi,i have a 2 cisco routers connected over vpn, Site A (the office) and Site B (remote site)the sites are able to connect to eachother but the router on the remote site cannot ping anything in the office. even though the computers in Site B can conne...

smithcolm · 08-08-2013

Hi,I know theres loads of discussions about giving access to DMZ from Inside network.I got this to work, but there were some side effects....say my inside network is 192.168.2.0DMZ is 10.10.1.xits on an ASA 5510 - which is not the default gateway on ...

smithcolm · 04-02-2013

hi,I want to be able to put an access list on an interface that has multiple addresses / subnets,i want the access list to restrict traffic from each network.its on 1 interface because i have limited resources and i need to build a lab environment fo...

smithcolm · 03-15-2013

Hi,I have a Cisco ASA 5510I am using ASDM 6.1I have a LAN and a DMZ and an internet connection.I am using one of the internet connection IPs to host a HTTP service on a server in my DMZ. (its the same interface as my internet connenction but a diffe...

smithcolm · 10-08-2013

also put in a NAT exempt rule here

smithcolm · 10-08-2013

pic is ACL from ASA (asdm)10.2.10.0 is site C and Saudi/16 is Site B (10.200.x.x is Saudi office too, 9/10/11/12/13 + 14 - over complicated setup - not done by me)these are the ACLs on the Saudi (site B router)101 is internet, so this restricts net...

smithcolm · 10-08-2013

I went down the ACL route and this worked for mei used the ASDM gui for Site A ASA 5510, went into the ACL "outside cryptomap_1" this connected site A to a remote VPN site B (cisco 1921)i added ACL source for subnet in Site C and destination site Ba...

smithcolm · 10-03-2013

I am not sure if there is a requirement for this, as exchange is working..in fact i am not going to bother even trying because i have been told we are updating exchange in the next few weeks.thanks for your help though! :-)

smithcolm · 10-03-2013

I dont know either, i'm also trying to follow up on that too!!Cisco Adaptive Security Appliance Software Version 8.2(4) Device Manager Version 6.2(1)theres no real complex NAT stuff going on, the box is not the default gateway of most devices here, i...

Member Since	‎08-21-2012 06:29 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	48

User Statistics

User Activity

DNS doctoring / rewrite / hairpinning not working

allow router to access network and vice versa

CISCO ASA 5510 - access to DMZ

Access list on 1 interface with multiple addresses

allow local network to access public internet address on DMZ

Re: Routing VPN traffic to multiple subnets

Re: Routing VPN traffic to multiple subnets

Routing VPN traffic to multiple subnets

DNS doctoring / rewrite / hairpinning not working

DNS doctoring / rewrite / hairpinning not working