Greetings, id like to deploy some 1530i access points in bridge mode between two points located ~250m apart, however i'm unsure of the range these AP's will support using the internal antennas or whether the beam with is small enough to cover the dis...
Greetings, we have a very busy guest/byod wireless network which has recently started to exceed 1000 clients on a regular basis, up until now it has worked without issue but have had reports that people are frequently unable to connect to the interne...
Greetings, we have two 5508 WLC's in our HQ, all AP's connected in local mode and heavily use MS Lync over wireless.We have 5 SSID's configured for various functions, one of which is the corporate SSID which users associate to by default, at present ...
Greetings, i'm looking to deploy two Cisco 5508 WLC's in a HA pair and license them to support 150 2600e AP's.Would the BoM below be sufficient? As i understand the HA controller doesnt need licensing as in the event of the primary controller failing...
Greetings, i have an OM1 MMF fiber run between two switches, the first being a 3750 and the second being a 3550.The link currently exceeds the maximum distance for OM1 @ 1000Mb/s (220m) so i would like to downgrade the link to 100FX using the necessa...
Thank you for your reply Jon, yes wasnt looking to load balance but ensure that if we do exceed the maximum number of translations on the first IP address it will use the next pool member. Appreciate the validation. Regards
Cheers Steve, have altered my cos-dscp map to mls qos map cos-dscp 0 8 16 24 32 46 48 56 and the wired PC is now seeing incomming traffic from the wireless client as EF rather than CS5.Looking through mrncciew.wordpress.com to get a better understand...
Have thus far had the following resultsOne laptop connected to wireless, the other connected to wired LANWireless Laptop - 10.45.57.134Wired Laptop - 10.45.35.13Also using default COS-DSCP maps on switches Cos-dscp map: cos: 0 1 2 3 4 ...
Thank you for your replies, i had specified the 2602E as we need to mount the access points on a vertical rather than horizontal surface approximately 3 meters off the ground and wanted to have better control over RF dispersion. If you say that the 2...
