I cannot find a way to update softkey template with BAT. The functionality does not seem to exist. Does anyone know of a workaround. I want to remove softkeys that were added after upgrade.

I need to set up a dial plan in h.323 gateway to provide second dial tone to user placing call over voip networkUser on PBX would dial access code (8) that would be passed to Cisco gateway. I want to configure dial peer to see this access code, provi...

I have a 3745 with t1 gateway module. T1 is connected from pbx to 3745. I want end user (behind pbx) to dial access code such as 81, then have pbx send call to 3745 for routing over voip network. Example: pbx user dials 81 gets dialtone, then dials r...

I am using CM 4.x and have RTMT installed on seperate server to monitor Call Manager. The defualt alarms only seem to work when the server is running and a service fails. RTMT does not alarm if I shut down the CM server, even if for an extended perio...

I upgraded from CM 3.3.4 to CM 4.01 and now the ccmadministrator page does not display correctly and I cannot update phones (get browser error and update never takes). I have MMLA enabled, but I know longer get login page as I did with 3.3.4 version....