Hi,I believe you have an EHWIC-VA-DSL-A card installed on the C1921 device.The sample configuration for the same would be as follows,1. Configure the Controller,controller VDSL 0/0/0 operating mode vdsl2 firmware filename flash:vdsl.bin-A2pv6C035j12....

Hello Peter,I think I missed the long history of steps that were suggested here and I just wanted to provide the config Phil was looking to realize the set-up.Sorry for any inconvenience caused.I agree with your views on the above 3 commands, but I c...

Hello Aliou,Like you've mentioned, getting an IP address on the Dialer interface simply means that the DSL has trained UP and connection has been successfully established.Now, in order to reach out to any IP address on the internet, make sure you hav...

Hello Aliou,First of all, kindly let me know what exactly is the issue.We need to understand if the DSL line is failing to train up (Layer 1 i.e Controller is UP or DOWN) or is it the Layer 2 (PPP) that is failing.However, to start with, I will provi...

Hello Phil,Based on your description, I understand that you have two ADSL connections and you need configurations to set-up the PPPOA connections and also would like to have a fail-over functionality between these two WAN connections.Please find the ...