We have an ASA 5515-X running 9.2(4) firmware with AnyConnect users and site-to-site vpns configured. All works fine (including hairpinning to the site-to-site connections), but I have been asked to change the config so that AnyC users can access a ...
Hi,We currently have a Hub - Spoke setup with many static-to-static lan-to-lan vpn tunnels configured.I have been asked to set up a vpn from the hub to a remote site which uses dhcp to obtain its peer address.I have searched for an answer to this, bu...
I am trying to configure a SRP527W for a remote site.It needs to connect back to our Central Office, (via an ASA) which has several VLANs configured. I have entered the configuration for an IKE policy, and one for an IPSec policy (I can only enter o...
I am having a problem configuring a VPN connection from a 1721 router to an ASA5520.The router has already been configured, but I have been asked to setup the VPN.I think the issue is because they are using a Loopback interface (which I have never co...
Best I can do - saves as a pcap file. This is the merged ingress and egress files. It looks like AnyC client (10.1.66.1) can send out to server (157.97.111.48), and server tries to reply (to the public ip), but it doesn't get through the ASA back t...
I think this may have worked (the packet tracer in ASDM shows it as working), but I won't know until the servers are configured and connected.Once I know for sure, I will mark the answer as correct. Many thanksPhil
Any chance of an example config? Is the below enough?tunnel-group DefaultL2LGroup ipsec-attributespre-shared-key TESTKEYcrypto dynamic-map DMAP1 500 set transform-set MYSETcrypto map REMSITE 500 ipsec-isakmp dynamic DMAP1