About Sergey Popov

Sergey Popov · 07-17-2015

Hello.I have CUCM 10.5.2 and CPCA 10.6.CUCM cluster discovered succesfully. It is in Managed state and all of passwords are correct.I have problem with CUCM endpoints discovering. There were not any endpoints in the "Current Inventory". And after run...

Sergey Popov · 05-13-2015

HelloI had error on web interface of C40. It was maintenance page with such recovery options as upgrade factory reset and something else. Upgrade didn't help - on web interface still was only the maintenance page.And after factory reset I can’t ping ...

Sergey Popov · 08-06-2015

I don't resolve it. I have demo soft so I can not open a case.I did the same config at dCloud and everything was fine

Sergey Popov · 07-20-2015

Thank you, Manish.But it doesn't help.Application user have roles Standard AXL API Access, Standard CCM Admin Users, Standard CTI Allow Call Monitoring, Standard CTI Allow Control of Phones supporting Connected Xfer and conf, Standard CTI Enabled, St...

Sergey Popov · 05-14-2015

URL to files pkgextract.elf & u-boot.ini from this document not works.Does anybody have these files?I had started upgrade without these files and I have big trouble now - Any image can't start and I don't have any access to codec. Thank you

Sergey Popov · 05-13-2015

Hello Dmitry. Thank you for your reply and for this guide.Now I try to assign IP to the codec

Sergey Popov · 05-13-2015

Hello Oleksandr. Thank you for your reply.I tried this command. I have only one image:selectswimage2 - TC7.3.2 14ad7cc [ACTIVE] [SELECTED]OK

Member Since	‎06-16-2011 06:08 AM
Date Last Visited	‎07-08-2020 08:41 PM
Posts	10

User Statistics

User Activity

CUCM IP phones not disovered from Prime Assurance

Telepresence codec C40 recovery

I don't resolve it. I have

Thank you, Manish.But it

URL to files pkgextract.elf &

Hello Dmitry. Thank you for

Hello Oleksandr. Thank you