I may be trying to compare apples to oranges but when I run a show interfaces serial 1/0 from my own router I get the following output, which shows a problem I'm having with input packets: cisco#show interfaces serial 1/0Serial1/0 is up, line protoco...

Does anyone know if there is another support avenue for AT&T circuit testing and support. I've used the (888) 613-6330 support number but support there has gone down hill to being just bad. I just was wondering if there was a US call center they don'...

I recently did an upgrade with AT&T from an older ADI/MIS 45M/45M DS3 circuit to a ADI/MIS 100M/100M circuit. Both of these are being provided over fiber run into my office. Both of these are serviced by my local LEC Frontier Communications. In the p...

I run a small ISP and have used IPV4 for years but don't "own" any of my ranges so upgrading bandwidth becomes a challenge as IPV4 addresses have become scarce.  I would like to migrate to an IPV6 range that I acquire from ARIN but what I've read so ...

I am looking for the cisco terms used to describe route failover between two routers.  I have a circuit through AT&T and the last time I upgraded the tech set it up so while my old router (cisco 7204VXR) was turned on and the line protocol was up my ...