I have two ACI fabric site and the Cisco Multisite established between the two spine switches to exchange the VXLAN's so my question if i need to extend vlan x by create new tenanet x and application profile x and new vrf x and epg x , can i make it ...
I have two tenants (two different VRF's) and each one has different EPG's(different BD's and Vlan pool) and the gateway will be the active firewall and physically the active and standby connected to the two borders as vpc
my question :
- i will ext...
If i have cat 9300 in SDA can i use the extension module (fiber , uplinks) to connect AP's or any user devices or it is used only for the uplinks between the fabric edge switches and the borders
I have DMVPN QOS implemeted in one tunnel associated with one physical ISP and it worked fine between the HUB and spoke , my question there will be new ISP will connect the hub and new tunnel will create it so my question can i use the same group nam...
in ISE , I will create many authorization profile and each one include the specific parameters (VN name, SGT name , Pool name) and this parameters should match the names in the DNA If i have Authorization profile 1 VN ENG SGT HR Pool name 172.16.1.1...
So if i have existing 4 leaf switches and we purchased 4 advanced license and then i converted the leaf switches to the ACI by upgrade the software and discovered by APIC so how the existing nexus can get the advanced license which i purchased it ?? ...
I think there is another solution to make two L3out one for the first VRF and second for the second VRF and will make the firewall which connected to ACI L3OUT to make the routing between the two VRF's
I have a question
If i have Cisco ACI Multisite ...
I have some questions for the Multisite
1-the BD multicast in site-1 255.1.0.0/16 and for the site-2 255.2.0.0/16 correct ?
2-the tenant and the VRF can be the same between two sites.
3-If the GW for the all servers in the two sites is the FW and ...
I have the same problem when i tried to make static port assignment for specific ports, it gave me error ""NCSP10246: Internal error while attempting to transform the object for further processing. Check the provisioning logs or contact the TAC"" so...
