About dhananjeyan_t

dhananjeyan_t · 10-11-2012

I have VG204 configured as SIP , SIP trunk is established to CUCM 7.x , Outbound to PSTN calls is not happening but Extension dialing within CUCM DB is happening. Inbound from PSTN works..Call manager is not forwarding the calls initiated from v...

dhananjeyan_t · 10-09-2012

I have VG204 configured as SIP , SIP trunk is established to CUCM 7.x , Outbound to PSTN calls is not happening but Extension dialing within CUCM DB is happening. Inbound from PSTN works.. Call manager is not forwarding the calls initiated from vg2...

dhananjeyan_t · 10-11-2012

Thanks Joe ,on cucm for any outbound call 0 is set as prefix , same way i am trying to use it on VG204 Extns , if i dial "0" followed by valid PSTN number CUCM should match the digit and route the call via PSTN gateway.Inbound from PSTN network to VG...

dhananjeyan_t · 10-10-2012

To solve Complete this procedure:ProcedureStep 1 Make sure the LSC is installed under the personal certificate store. From Start > Run, entercertmgr.msc.Step 2 Select Personal > Certificates, and make sure the device name on the certificate matches t...

dhananjeyan_t · 10-10-2012

Can someone assist me pls.

dhananjeyan_t · 10-09-2012

Hi , pls check the capacity on Servers associated to device pool u allocate the CIPC .

Member Since	‎10-09-2012 05:44 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	6

User Statistics

User Activity

VG-204 SIP - PSTN outbound not happening from CUCM

VG-204 SIP - PSTN outbound not happening from CUCM

VG-204 SIP - PSTN outbound not happening from CUCM

CIPC phones wont register when they are allocated to a device po

VG-204 SIP - PSTN outbound not happening from CUCM

CIPC phones wont register when they are allocated to a device po