Hi guys,I'm trying to configure a T1 controller (VWIC-1MFT-T1) for voice which is installed on a 2651XM (12.4(15)T9).After I've set it up, it came up and the serial0/0:0 was created and was up. The problem is I can't find any voice-port in the config...

Hi guys,I have a question regarding the UC500 models.Would it be possible to use an analog line with the UC500?I've used SPA3000 till now and I'd like to integrate a UC500 with multiple analog lines.Has anyone had this scenario before?Thanks.Regards

Hi guys,I try to set up a video call between 2 7985 phones over a SIP trunk. The SIP trunk is between 2 CMEs, one is Vers. 4.1 and the other one 8.6.Audio works but I get no video.If I do a video call on the LAN it works. The problem is somehow with ...

Hi all,I'm trying to configure a 1751V with a E1 card (VWIC2-1MFT-T1/E1) for the following:timeslots 1-15 have the nr 555-111timeslots 16-24 have the nr 555-222if someone dials 9... it should go out over 1-15if someone dials 8... it should go out ove...