About c.console

c.console · 04-14-2024

Hello everyone and thanks in advance for your support,one of my clients asked me to reuse an ASA 5506 so as to be able to allow some users to connect remotely via Anyconnect.However, the request requires the use of the tunnellall option for obvious s...

c.console · 12-11-2020

Hi everyone, in my company we have implemented authentication towards azure AD on an asa. From the clinet for Windows, Linux and Mac everything works perfectly but if we try to use the Anyconnect client on iPhone or Android the connection is not term...

c.console · 02-23-2016

Hi all, 2 days ago a customer have changed his ISP. The new ISP have configured a router with a gui with ip address 172.16.0.1/24 address The ISP Router have a GUI for port forwarding and basic configuration. From the GUI i have configured a NAT for ...

c.console · 09-14-2015

Hi,I have two office (main and brach) each with a cisco 887 router 15.3 with sec+ k9 iosI have configured client vpn (working with no problems at all) and a site to site VPN.The tunnel between main and branch site is up (according to sh cry session a...

c.console · 09-02-2015

Hi,I need a little help.I have 2 office to link with a site to site vpnEach site have a 800 series sec- k9 router.Each router actually have client ipsec vpn enabled and all users can connect using the vpn client without any problems.I have added the ...

c.console · 02-24-2016

1) I have asked but i'm not too confident about a quick repsonse 2.1) No, simply the von server appear to be offline or unreacheable 2.2) No login prompt only "Connection attempt timed out" error 3) Simply ISP Router -> Internal router the internal n...

c.console · 02-23-2016

Hi The ISP support have perform a check on this router. No ACL seems to be active on the IN/OUT interface...

c.console · 09-14-2015

Thanks now i can send traffic trough the tunnel.Just a little problem...If i connect with the vpn client to one of the 2 routers i can reach only the subnet directly connected but i can't reach the other side of the ipsec tunnel.For example if i conn...

c.console · 09-10-2015

Hi After this the tunnel is UP (on the output of sh crypto session and sh crypto isakamp sa)I have added no-xauth on the peer line and now i see the tunnel in active stateBut...I can't send traffic between the two routers.I must add some static route...

c.console · 09-07-2015

Yes, Before the sh crypto ipsec sa: Router A ping 192.168.1.100 (a server on the router b network) source vlan 10 Ping failed Router B ping 10.0.0.254 source vlan 30 Ping failed I have re-checked the sh run and on both sites the nat exclusion seems t...

Member Since	‎09-18-2011 02:29 AM
Date Last Visited	‎04-14-2024 07:41 AM
Posts	23

User Statistics

User Activity

No internet using Anyconnect with tunnellall options

Anyconnect with Azure AD - Mobile client problem.

Anyconnect connection fail after ISP change

Site to Site VPN in UP-IDLE and no traffic...

Problem about site to site and client vpn between 2 800 series router

1) I have asked but i'm not

Hi

Thanks now i can send traffic

Hi Now the tunnel is UP (on

Yes,Before the sh crypto