About Marcofbbr

Marcofbbr · 03-17-2013

Hi,I have just completed reading the best practices for fabricpath and vPC+ and now I should create my first network design with Nexus devices..If you take a look at the attached picture, you will notice that I divided each Nexus chassis in two virtu...

Marcofbbr · 04-03-2009

Hi,I'm studing for MPLS exam and after reading the documentation some aspects about MPLS-TE are still not clear .I hope you can help me to clarify some concepts:1)Is RSVP a requirement on every router link of the ISP when we are using dynamic tunnel...

Marcofbbr · 01-15-2009

HI,I'm studyng for MPLS exam and I wanted to create a small lab to recreate a scenario with overlapping MPLS-VPN to make some practice.I created the following physical topology:ACentral-\ $$$$$$$ /---BCentralSiteB2---Pe1--P--Pe2--SiteA2SiteA1---/ $$...

Marcofbbr · 10-20-2008

Please the the attached text file for the question...

Marcofbbr · 08-20-2008

In BGP Student Guide version3.2 slide 3-54 you can find this example:"Requirement: The ISP router will not accept routes with subnet masks longer than /24; subnet masks from class B address space will be no longer than /20."This is accomplished with...

Marcofbbr · 01-15-2021

Is the RSSI visible with that command output measured on the AP or measured on the client? I expect it to be measured on the AP and I wonder whether there is a way to check the client measured RSSI from the AP.

Marcofbbr · 06-08-2019

Hi,I had a similar problem using dynamips and IOS c7200-advipservicesk9-mz.152-4.S5The packets were dropped somewhere in the device.I think the above IOS does not work properly with dynamips.After testing the same identical config with GNS+IOU the pr...

Marcofbbr · 04-07-2013

Hello olpeleri,I am studing IPsec and I came across this interesting thread.Could you please clarify or confirm that what I am writing below is correct ?PC1-----R1-----(ipsec)-------R2------PC2==CASE 1 : IPSEC is set to transport mode, gre is not con...

Marcofbbr · 03-24-2013

Hello Richard,I was testing IPSEC in my lab, and I noticed that OSPF works even when only IPSEC(w/o GRE) is configured.I was quite surprised to see the adjacency UP.Perhaps it depends on the cisco IOS release ( I am using Version 12.4(15)T10)?I was n...

Marcofbbr · 01-07-2013

Thanks guys,I definetely have to read more in detail about fabric-path! I thought it was used for remote DC interconnection only.@Onanis: "It really depends with your objective"=> Well the objective is mainly to introduce a new technology that offers...

Member Since	‎06-21-2004 04:10 AM
Date Last Visited	‎01-04-2023 11:07 AM
Posts	33
Total Helpful Votes Received	10

User Statistics

User Activity

Nexus 7010 hw design with VDCs. Doubts.

MPLS-TE : some question

Overlapping MPLS-VPN problems

BGP: need clarification about peer templates

BGP prefix list .... need help

Re: CLI to see RSSI of associated clients on Autonomous AP?

Re: GNS2 - VTI IPSec IPv4 between 2 routers up but no traffic sourced from LAN endpoints pass the tunnel

Re: Issue of IPsec VPN network over transport mode

Re: OSPF over IPSEC???

Re: Need some hints migrating to nexus