I have an inherited ASA 5505 V09. It will not allow connection to the ASDM web page using the default IPaddress followed by /ADMIN. It does provide DHCP address assignment to connected devices. It does respond to the console connection using a ...
Wow! The past few days have been a roller coaster for me. I have corrupted the configuration file, corrupted the configuration register, learned many new (just the beginning) ASA commands, discovered priceless investigation techniques, learned the ...
ciscoasa(config)# show sslAccept connections using SSLv2, SSLv3 or TLSv1 and negotiate to SSLv3 or TLSv1Start connections using SSLv3 and negotiate to SSLv3 or TLSv1Enabled cipher order: rc4-sha1 aes128-sha1 aes256-sha1 3des-sha1Disabled ciphers: des...
Sorry I didn't reply sooner. I inadvertently lost the configuration but I think I'm OK now. I'm using asa821-k8.bin and asdm-621.bin on the appliance. I added the command asdm image flash:asdm-621.bin to the restored factory configuration. I am u...
I connected to port 2 with the computer and entered http://192.168.1.1. Then I entered http://192.168.1.1/admin. In both cases the Internet Explorer cannot display the webpage was received. I have attached the short debug information.debug http 2...
I entered priveleged configure mode and issued the command as you specified. It did not appear to change anything. It did seem to accept the command. Did I enter it properly? I am new to this so you may have to be very exact as to where you want ...