About pezhmankh

pezhmankh · 04-05-2013

In the exams there are usually questions similar like "Which IP addresses are valid for hosts belonging to the 10.1.1.160/28 subnet" for this kind of problem I usually calculate the network and the broadcast address by adding the number 16 in this ca...

pezhmankh · 03-18-2013

Show Controller command's result: http://i.imgur.com/QfeaZ1I.jpgI was wondering how do I vertify the following on the serial 0/0 of a router by looking at show controllers command result?An external CSU/DSU is not in use.No clock rate is set.The int...

pezhmankh · 02-26-2013

HelloI'm studying a question that asks if the user can conclude the interface is operational and handling traffic?Here is a sample diagram, and I was hoping to learn which lines should I specifically pay more attention to find out if there could be a...

pezhmankh · 02-25-2013

HelloI am studying for CCNA and I was hoping to learn what is the requirement for two routers to be connected?I know they have to be on the same network using the same protocols, but what is the role of username and password here? Do they have to hav...

pezhmankh · 02-24-2013

Hello The question is, In a network diagram There is PC 1 That is connected to switch 1 > connected to router 1 connected to > ISP and ISP connected to Server B.How many times will a packet be encapsulated when Connection to Server B from PC1?

pezhmankh · 03-19-2013

Hello and thank you for your respond.Although I am still a bit more confused so I try to be more specific in this reply. As I mentioned the correct answer is there is no CSU/DSU is in use and No clock rate is set. So there is no DTE serial cable atta...

pezhmankh · 02-26-2013

Thanks for letting me know, Although its very strange I can perfectly see the output from my perspective. However here is the link to the output: http://openmaniak.com/vyatta/vyatta_case1_cisco2651-int.gif

pezhmankh · 02-25-2013

Hello Toby Thank you for your respond.I was expecting an answer with username and password have to be the same because this was the answer to one of the sample questions I am studying, I'm going to write the configuration to be more clear.Router 1 Co...

pezhmankh · 02-14-2013

Thanks so much John and Mahmood, Although I have a question for mahmoodmkl, Why wouldn't user be prompted for password for the first 5 VTY connections but user and pass for the 5-16?

Member Since	‎02-13-2013 06:42 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	11

User Statistics

User Activity

Suggestion for tips during the exam test?

Show controller on router question

Which Statement describes router is operational?

What is the requirement for two routers to be connected?

How many different frames packets are encapsulated?

Show controller on router question

Re:Which Statement describes router is operational?

Re:What is the requirement for two routers to be connected?

Re: Start up configuration question