About amir2012cs

amir2012cs · 02-03-2013

Hi,I have a trunk between a panasonic-tda and CME. all calls are routed succesfully and both can call each other but when an extension in CME side has forwarded his/her extension to another number, the calls from the panasonic to that extension in CM...

amir2012cs · 03-11-2013

Hi,unfortunately i'm not sure about the type of the trunk we are using. We've just setup a "voice dial-peer" in cme to route special calls (accroding to their leading number) to an IP address which is the IP-gateway card in the panasonic side. This c...

amir2012cs · 03-06-2013

HiPlease find in attached the required files:configuration.txt > configuartion of the CMElog sip.txt > brief log of what happens during an unsuccesfull call forward. In the case, 290 is forwarded to 282 and 663 is calling 290 and call failes.putt...

amir2012cs · 02-04-2013

HiWe are using an IP-gateway card on panasoinc and a dedicated WAN link to connect it to the CME. Cisco side is using a sip trunk (dial-peer voice).Thanks.

amir2012cs · 02-01-2013

Dear Dmitri,I have the same problem in my network. I have a trunk between a panasonic-tda and CME. all calls are routed succesfully and both can call each other but when an extension in CME side has a call-forwarding rule, the calls from pana to tha...

Member Since	‎02-01-2013 11:08 PM
Date Last Visited	‎12-30-2020 01:20 AM
Posts	5

User Statistics

User Activity

call-forward problem between CME and panasonic tda

call-forward problem between CME and panasonic tda

Re: call-forward problem between CME and panasonic tda

call-forward problem between CME and panasonic tda

Call forward through external PBX